4GUK

Hi guys. I have a sedan with a D13 as a daily driver. I am very happy with it, but my only issue is that when I turn on th A/C, the idle speed goes very low and the car nearly turns off. Is this normal with these engines, or is there something I should check? The car does not have any other idling p...

Hi guys, I know this could have been covered but I can't find any info about this. I would like to fit a side-mounted full bucket seat to my 4g but it seems like its a bit of a pain to get it to fit as low as it could go. What is the easiest way to go around this please? Buddyclub used to make a low...

Once again I need some advice. Are CRX VT and Civic VT front knuckles the same?

Thanks once again,

Chris.

Just another quick question. Would EG6 discs and calipers fit on the VT knuckles?

Chris.

Hi, thanks for the info. I am using an EG6 hydro gearbox and intermediate shaft. So that means I can use EG6 drive shafts with VT hubs right. So this means that EG6, EF9 and 94+ Integra drive shafts are all the same length right? It is all up to the hubs to produce different offsets. Thanks, Chris.

Hi guys, I have practically taken everything out of an EG6 and used it in my 4G Civic hatch when doing my B16 swap. I have even used the front hubs from the EG6. Now, this hasn't bothered me much, but lately I was getting a bit annoyed about the fact that I have a little bit of positive camber at th...

Hi. Well done for a cool saloon. Just out of curiosity, what is the front lip that you put on it? Because I am currently looking for a front lip for my saloon and I quite like yours!

Chris.

So, I have a b16a from an EG6 in my Civic. I just wired an EF9 cluster into it. Now, the thing is that the rev counter is playing around. Vtec kicks in at around 4800rpm and the limiter hits at either 7000 or 7500 rpm. Before I put in the EF9 cluster, I tried it with an EG6 cluster and everything wo...

Or just buy this one...

http://www.pistonheads.com/classifieds/ ... ap/1426765" onclick="window.open(this.href);return false;

http://item.mobileweb.ebay.co.uk/viewit ... 5523045382" onclick="window.open(this.href);return false;

Plus you can get low rails for your seats which will get you further away from the bars.

Hey. Yes, you can use the full EG wiring loom in your ef. I did mine that way. All you need to do is cut off the plugs that go to the EG cluster and re-wire them to the EF plugs. All you need are good pin-out diagrams of both the EF and EG clusters. Apart, you will need a new cluster, either an EF9 ...

Hi guys. My friend bought a B-swapped Civic. He has the EE9 brakes and hubs at the front but whoever did the swap put ITR DC2 brakes at the back. That means that his car has a PCD of 4X100 at the front and 4X114.3 at the back. He would like to get the rear in the 4X100 format. What are the options? ...

That's the way I had ordered...via email and Paypal.

Yes. Was quite happy with their service. And they managed to ship what I wanted to Malta without any problems.

Chris