4GUK

Has anyone on here started making these yet, for a VT?

I know Stew@PPW does them for 16v's (£50). And I also have seen the one's on ebay for VT's, but they are £80 which is a bit OTT.

this place any good?

http://www.car-stuff.com/mmparts/honda-crx/car_bra.html" onclick="window.open(this.href);return false;

Considering its a US site, i doubt they will fit VT's.

Dont get one Marc, you will regret it

Cause more harm than good tbh

They look good on a udsm styled ek but not a 4g IMO

Are they only available in black ?

Any other colours ?

Gizmo wrote:Dont get one Marc, you will regret it

jakescool1234 wrote:Cause more harm than good tbh

Why?

I want one to stop my bonnet getting chipped/dinged which is does quite easily. I bought a MINT bonnet not long ago, after a few months it had dings and was chipped to hell.

I should of showed you at jae

My bra has rubbed through the paint in places down to primer. And has Hadley scuffed areas aswell. I know my bonnet needs TLC anyways. Hense I'm not bothered.

Had a furry lining aswell and still rubbed though

Gizmo wrote:I should of showed you at jae

My bra has rubbed through the paint in places down to primer. And has Hadley scuffed areas aswell. I know my bonnet needs TLC anyways. Hense I'm not bothered.

Had a furry lining aswell and still rubbed though

I actually did notice that, but you have an EK one don't you? And doesn't your bonnet have no lacquer on it also?

It was an EF fitment one

The top half of the bonnet had no lauqer. But the bit the bra covered did. As the aids hadn't spread that far yet

Could it be that you didnt fit it properly? I'm pretty sure you told me it was an EK one mate.


And what's aid's got to do with anything?

Why not just get your bonnet and bumper wrapped in some quality clear vinyl? Cheaper, does the same job, and if done properly you'd never know it's on there.

I don't think that would stop dents though would it?

I got it cheap. Because stoo ordered an EK one but it was an EF one in the bag.....