My Si Ef-3 h22a hatch build

[walsh123]

Sounds good man, i think you will be the first ti finish a H22 build on here

Also check your inbox

[vtecmossy]

Really taught there would of been one done before makes it seem very cool
know of one other one being built in ireland but i`m further along than that one so should be on the road first

Pm replied

[walsh123]

Haha nice, its all happening in ireland

There was another one on here awile ago but dont wknow if he ever finished it or not.

Also need a contact number and postcode for courier aswell mate

[vtecmossy]

Sent you them

[walsh123]

I havent got a Pm bud ??

[vtecmossy]

send it again sent off phone last night

[rob s]

hi matey, great build so far, i have just finished wiring in my h22 and hope to have her on the road on friday this week!

will get lee1431 to pop some pics up asap

cheers

[rob s]

lee4391 lol sorry

[vtecmossy]

Cool I'll look out for it nice to see another 4g with h swap

[rob s]

h22 ed7 =

[vtecmossy]

So got the arch more finished just a few spots then finished all the bodywork patching and welding





Loads of dressing and shaping to do before paint but less rust so result

Primed the wing and few other spots on the rust free side






Had to chop the headlight surround and the head light bracket a bit to clear the alternator





Striped out the interior again so could change the colour on all the bits that will be covered with trim bit of a test spray loads of prep to do till it`ll be painted properly



Welded in the battery tray to the boot just need longer cables and to make a box when the trim is in place



Got my rear lca i needed cheers to walsh123
Should be getting my ek hatch skirts in next few days
And my rear calipers
Just need Rear lip and pinstripe side trim anyone got some

Should have few more updates soon enough seems some parts are coming in

[Lee4391]

Robs's

[vtecmossy]

Robs's

Very nice not weld in the gearbox mount them little bolts dont seem up to the job for me so there gone

[rob s]

Yeah mate im going to weld it in, just wanted it running asap lol

[vtecmossy]

True but no point rushing it esp when the motors such a pig to get in and out

Dropping mine out for the last time this week to sort my bay but still not sure if i should remove all the sealant and weld it instead to stiffen the front for the motor or should i just brace it like crazy opinions on a post card also should i give it a full tuck or just a tidy tuck would be just removing the fuse boxs and brake lines into the cab and rerouting a few other bits or go wild and hide every engine wire with a full on tuck