im not changing it lol, going to let Daz handle thatnominous wrote:Bear in mind you have a cable shifter...
I bought all (well nearly all, some bits missing I need to source) the parts to beuild my shifter. My spare one is really loose too. They wear out. You need to make them good and tight again, also he cables can be adjusted. Rightly or wrongly.
Regards changing the sump gasket.
Good luck.
I wont spoil the surprise, just don't take anything off you can't get back on again when you have had enough of it
as i know they are a pita, and i could possible need a new sump, as mind has lots of rust blisters
re: shifter cables... are you on about my "gear wont select" issue?
ive been working on a few bits yesterday, and notice there does seem to be a leak on the g/box. but not enough to have any on the floor
yesterday i took off the old fogs and wiring, and wired in the actual shuttle fog wiring i managed to get off the Beagle. refitted the bumper and front looks all good apart from two holes in the bumper. im going to flush the holes over, and re-cut them. and then just need some fogs to fill them
fitted an EK9 throttle cable, had to make up a bracket, which took me a couple of attempts.
i want to do some painting, but its too cold and wet for that
