EFK9 B16B - The Speedboat
Re: NH-512Z EE9... B16B Speedboat
My vote for silver.
It looks simple and it really works.
It looks simple and it really works.
Re: NH-512Z EE9... B16B Speedboat
I'll raise the rear and stick the mudflaps back on tomorrow, should improve it. I think a dark grey might clash...
Re: NH-512Z EE9... B16B Speedboat
Gunmetal grey will look spot on
Sick Civic VT OfTeN LiCkEd NeVeR bEaTeN
Re: NH-512Z EE9... B16B Speedboat
I did a little photoshop last night, and gunmetal doesn't look right on a white car.
think i'll stick with silver, just find a different shade.
think i'll stick with silver, just find a different shade.
Re: NH-512Z EE9... B16B Speedboat
Can't get an MOT until Thursday 22nd.
- EE9 CVC
- Lvl7! Post Whore y0!
- Posts: 3481
- Joined: Tue Dec 11, 2007 5:57 pm
- Location: Portrush - NI or on Indian Empress
Re: NH-512Z EE9... B16B Speedboat
That sucks, nothing worse than wanting to drive a car and not being able to.
Re: NH-512Z EE9... B16B Speedboat
I should of rang up earlier to book it in. Never mind.
Re: NH-512Z EE9... B16B Speedboat
Thats because March is one of the busiest months for MOT's
1988 RT4WD Shuttle - Supercharged, VTEC Swapped Track Toy.
1988 RT4WD Shuttle - Lifted Daily Beater.
1988 RT4WD Shuttle - Lifted Daily Beater.
Re: NH-512Z EE9... B16B Speedboat
It may be the angle you have taken the picture from but they don't seem to suit your car, they look almost too big
Or it may just be my eyes.
Or it may just be my eyes.
2010 Audi A3 1.6TDi Sport
Re: NH-512Z EE9... B16B Speedboat
mmmm dunno white could work but id go with a darker silver
White ED7 - sold
Black EE9 - Rust can
Red EC9 - Rust can
Black ED7 - Written off
Superior blue ED2 - Sold
Black CRX EF6 Glassroof - in the making
Black EE9 - Rust can
Red EC9 - Rust can
Black ED7 - Written off
Superior blue ED2 - Sold
Black CRX EF6 Glassroof - in the making
Re: NH-512Z EE9... B16B Speedboat
This is the shade of silver i've gone for.
Re: NH-512Z EE9... B16B Speedboat
That shade should suit well congrats on the B16BMarc_EE9 wrote:This is the shade of silver i've gone for.
White GL
Unique Edition
Re: NH-512Z EE9... B16B Speedboat
Put some glass headlights in today, and also raised the rear by four rotations, which I would say is about 7mm. Might have to lower it a tiny bit, maybe back up two rotations.
Managed to tuck the throttle cable down out of the way as well. Not sure how that will pan out, should be ok.
I am left with a spare plug near the throttle body and a hose from the throttle body itself. I guess the plug is from a sensor...?
And what can I do with that hose from the m/c? is it filled with coolant? Do I need to drain the system to undo it?
Managed to tuck the throttle cable down out of the way as well. Not sure how that will pan out, should be ok.
I am left with a spare plug near the throttle body and a hose from the throttle body itself. I guess the plug is from a sensor...?
And what can I do with that hose from the m/c? is it filled with coolant? Do I need to drain the system to undo it?
- callum0892
- Lvl4 Nos Enhanced Poster
- Posts: 744
- Joined: Sun Dec 11, 2011 2:34 pm
- Location: Surrey/Bristol
Re: NH-512Z EE9... B16B Speedboat
Isn't the hose from that you put the line on the hose from the servo to inlet? if so, it's a vacuum hose that you do need,
Re: NH-512Z EE9... B16B Speedboat
I know I need it, i just want to make it shorter or re-route it, but wanted to check what was inside