Page 2 of 2
Posted: Tue Oct 06, 2009 5:44 pm
by Dan
Posted: Tue Oct 06, 2009 7:10 pm
by Gizmo
Jerrick on MeisterR Told me that the EG Forks and Loop Eyes are slightly bigger.
The Loop Eye brackets He sent me with my other bits and bobs were for an eg, they were a good 1-2mm wider than the EF Brackets
Posted: Tue Oct 06, 2009 8:02 pm
by Marc_EE9
just what i was after, cheers Dan
Posted: Tue Oct 06, 2009 8:51 pm
by Adam
I had a set of EG and a set of EK forks to use with the D2's on my DX. They were identical
Posted: Tue Oct 06, 2009 9:40 pm
by Dan
Marc_VT wrote:
just what i was after, cheers Dan
No problem
Its posted on here somewhere that link as a title, but i couldn't find it - managed to get it off my old laptop though
Posted: Tue Oct 06, 2009 9:42 pm
by Marc_EE9
Dan wrote:Marc_VT wrote:
just what i was after, cheers Dan
No problem
Its posted on here somewhere that link as a title, but i couldn't find it - managed to get it off my old laptop though
yeh i was looking for it too, but couldnt remember where'd i'd seen it
im looking for some coilovers for the shuttle, and I have CRX jdm rear LCA's, and a mate has some EG front forks, so im all covered.
there is a decent setup going, but has no adjuster spanners
ive found some on ebay, not sure what to do now though lol
Posted: Tue Oct 06, 2009 9:50 pm
by Dan
I have two tein spanners you can 'borrow' if you want?
I do want them back though - my ground control coilovers are different so I don't need them at the moment.
Posted: Tue Oct 06, 2009 9:57 pm
by Marc_EE9
well the guy a tein one just fitted, and a hsc one for the bottom.
i have a few offers im waiting to hear back from, but ill keep that in mind, thanks dan
Re: EG/DC suspension onto a 4G
Posted: Thu Oct 08, 2009 2:18 pm
by Nocturnal
Marc_VT wrote:Quick question
Most coilover kits im finding second hand for the EG/DC have pillow ball top mounts, or top mounts specific for the coilovers, but my question is..., do the EG/DC top mounts fit onto the EE/EF? I'm sure I read somewhere they have thicker bolts?
The Top Mount for the EG will also fit the EF, just so you know.
The main thing you worry about is the "hole" on the pillowball top mount, as that have to be a perfect fit on the damper shaft.