Recently got a set of vt hubs and tried to get new bearings to fit but the bearings are the wrong size in the inner.
Would anyone have sizes of outer and inner? outer measures 80mm
rthanks in advance
crx vt bearings
crx vt bearings
Snookie want smoosh smoosh
Re: crx vt bearings
SimAuto does Genuine Koyo bearings for £35 a side!
1988 RT4WD Shuttle - Supercharged, VTEC Swapped Track Toy.
1988 RT4WD Shuttle - Lifted Daily Beater.
1988 RT4WD Shuttle - Lifted Daily Beater.
Re: crx vt bearings
Cheers Giz, any idea of the inner diameter? Was supposed to be vt i got but used the bearing that I was given to buy the other so don't know if that was wrong or hubs are something different?!
Snookie want smoosh smoosh
Re: crx vt bearings
Not a clue! I used VT Hubs with 16i Shafts. Used VT Bearings from SimAuto. Done the job just nice!
1988 RT4WD Shuttle - Supercharged, VTEC Swapped Track Toy.
1988 RT4WD Shuttle - Lifted Daily Beater.
1988 RT4WD Shuttle - Lifted Daily Beater.
Re: crx vt bearings
honest answer. my problem is that the centre of the hub is loose within the bearing. any ideas? differrent hubs? or just wrong bearings?
Snookie want smoosh smoosh
Re: crx vt bearings
I think the drive shaft diameter and splines are the same, Just outer Outer diameter of the spline / inner of the race is different between 16i and VT.
1988 RT4WD Shuttle - Supercharged, VTEC Swapped Track Toy.
1988 RT4WD Shuttle - Lifted Daily Beater.
1988 RT4WD Shuttle - Lifted Daily Beater.
Re: crx vt bearings
Turns out they 'could' be DA hubs. Discs are260mm Pain in the arse not knowing, bloody second hand parts
Snookie want smoosh smoosh